![]() ![]() Probably it would have been better to get taller monitors. I already had the 22″ monitors, so I used what I had to save money. Being able to look sideways out the front cockpit window is really helpful. In a real GA plane, before you taxi across a runway, you really should look to make sure no one is on final who will run into you. You might wonder why I bothered with the small monitors on the front left and front right. 32″ TVs for the windows in the left and right doors.Vertically mounted 22″ monitors for the left and right front.Displaysįor the windows, I used 5 total displays: They are uncomfortable, though, and will eventually be upgraded. Note that I could not afford nice C172 seats, and opted for cheap $40 boat seats. I know that it kind of looks like a covered wagon, but mostly you just want to feel enclosed, and when you’re flying the plane, you don’t look so closely at the covering. The figure below gives you an idea of the result: The PVC frame and sides of the box without monitors were then covered with fabric. To cover the top, I made a frame out of PVC pipe by heating it up and bending it to conform to a drawn pattern. #X plane fight simulator tvAlso, separate pieces were welded for the TV mount and vertical monitors on the sides. So, it comes apart into 4 main pieces: bottom, left and right sides, and the holder for the computer. The steel frame is not one solid piece, because I wanted to be able to take it apart and move it (like to campus where I would be teaching the class). The frame was basically a rectangular box, where a floor and seats were mounted on the bottom, doors were mounted on the side walls, and monitors were mounted on the sides and front. Luckily, there are good steel suppliers in the Lehigh Valley Area, and I purchased 96 ft of 1″ square tube and 20 ft of 1″ steel angle for $90 from Orkin Steel. What I came up with was to weld a metal frame using steel stock (square tube and angle) using a stick welder. Also, being able to see other people or objects in the room destroys the realism, so I needed some type of enclosure. #X plane fight simulator simulatorOne thing I feel is important for a flight simulator is that you feel like you’re inside of something and it probably should even feel a bit cramped if you’re simulating a small GA-type airplane like the C172. This page documents the result of that effort, and I hope it can be a source of inspiration for others who are looking to take their flight simulators to new heights. It wasn’t until I was slated to teach a freshman writing course at Lafayette College Fall of 2017 on the topic of aviation that I decided to make my simulator as realistic as possible, allowing students to use it as part of the course. #X plane fight simulator licenseAfter obtaining my private pilot’s license in 2014, I realized how my simulator setup felt like a game played at a desk and nothing like a real aircraft. In 2012 I became interested in general aviation and in flight simulation, and I purchased X-Plane 10 and Saitek yoke and rudder pedals. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |